Sometimes the latch, which the pull tab releases, gets stuck. That could cause injury to the person sitting there. After raising the rear seatback, always check to be sure that the safety belts are properly routed and attached, and are not twisted. The person wearing the belt could be seriously injured. Pull on both to release the back seat latches and then pull the seats forward. Pull forward on the seatback ta … b located on the outboard side of the rear seat cushion to fold the seatback down. These levers can be difficult to find if you do not know where to look, just look at the top of the inside of the trunk towards the … edge and you should find them.
This releases seat back to fold down. . There are two pull pin levers in the top of the inside of the trunk, these levers are very close to you when you open the trunk, they pull out towards you horizontally. You open the trunk and on the left hand side ceiling of the trunk you will see two nylon straps hanging. This gives direct access to the trunk. You just pull as someone p … ushes the seat down. Caution: A safety belt that is improperly routed, not properly attached, or twisted will not provide the protection needed in a crash.
Like my Follow Follow Subscribe above. Th … e pull tab for folding the rear seat on my 2-door is located on the seat portion on the passenger side of the rear seat. Make sure the front seat is not reclined. Caution: If the seatback is not locked, it could move forward in a sudden stop or crash. This is a quick how-to video explaining how I modified the rear seat of my 2015 Chevrolet Silverado crew cab so that the back of the seat would fold down, in addition to the seat bottom folding up.
If it is, the rear seatback may not fold down all the way. Pull up on pull tab at center back of seat and fold forward. Answer removal of rear fold down seat. Always press rearward on the seatback to be sure it is locked. To lower the rear seatback, follow these steps: Disconnect the rear center lap-shoulder belt latch, if equipped, by using a pointed object to press the release button. Leave it to a woman to figure it out.
After the bolts are removed the seat needs to be li … fted straight up to get the tabs at the top of the seat out of the holders. The one on the left is for the big side which has to open first. It may take someone rocking back and forth in the back seat while the other person pulls on the pull tab to release a stuck latch. The 5th nut is in the center on the floor and is attached to a v-cable that is also attached to the back of the seat. That's true, but to go all of the way down, you have to take the headrests out of the backrest and install it in the back end of the seat once it has been pulled forward. Then the one on the right is for the smaller side.
There is a little bit of space back there, and I was determined to use it. . . . . .
. . . . . . .
. . . . . .
. . . . .
. . . . . .