Underneath your lights are metal fillers that slide inward, be careful the bend quite easy. Cut the adhesive by pulling on the piano wire around the windshield, assisted by someone outside the car. It took me about 2. It is just a plug in pull out connection. I purchased my Sienna in January of 1998. Depending on wether you talking about the light bulb retainer of the head light assembly to include the lens you probably need to remove the air filter box on one side and possibly the battery on the other.
No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. It's usually not necessary to tighten the oil filter with the oil filter wrench, but have it at the ready if you're grip's not strong or large enough. Aiming is not neces … sary after replacing the bulb. Be careful not to overtighten the plug. First remove the screws holding the turn signal assembly, and then replace remaining screws holding the headlight.
You may need to twist and turn it a little to get it around some of the wires and hoses. I'm removing a cracked one already so that's not an issue. This joint must be separated to get at some of the mounting bolts. This is the best value headlight assembly I could find online. The front bumper will have to be removed in order to remove the headlight s. You have to loosen the entire bumper facia or bumper guard and pull it forward, in order to slide the old headlight assembly out and the new assembly back in. No need to aim if you just change the bulbs.
First remove all the bolts from underneath there are approximately 10 of them. Next, remove the rubber boot protecting the back of the headlamp. Tape the end of a scraper and insert between the body and upper windshield moulding. You can search youtube for that also, videos on how to adjust your headlight beams. When aiming adjustment is necessary,contact your Toyata dealer I have a 93 camry. Test the new headlight to make sure it works before closing the hood.
Unplug the electrical connector from the back of the bulb. Ready to dutifully serve you on your commute or on a cross-country journey, your Camry is primed for any sort of trip. Hi: My best bet is to remove the plastic container sitting behind the head light. To install a bulb, align the tabs of the bulb socket with the cutouts of the mounting hole. It was comparatively easy to install. This video applies to the Toyota Camry, years 02, 03, 04, 05, and 06.
Aslo in the center of the bumper top remove the plastic pin with the Phillips. Turn the plastice device to unlock it and pull back. The good news is that the company that I bought from is going to replace it, no questions asked. It makes sense when you try it, or just look in the owners manual. Here is the procedure I used from the 83-92 Chiltons Camry Manual:. Remove hood weatherstrip by pulling upwards. To remove the bumper you will only need a ratchet, small extension and a 10mm socket and a Phillips screwdriver.
It is located on the fender side of the headlight s just in front of the fender. Always start threading any bolts or screws by hand to prevent cross threading. If your car has a low clearance, raise it by driving it onto a ramp or by jacking it up and supporting it securely. Fourth, remove the two bolts that hold the starter. If you pull back the front of the inner fender plastics you will see the bolt.
I relied on a YouTube video for the installation. Twist it clockwise to secure its position. Could there have been a mid-year model change that makes your van different than mine? First carefully remove plug into the back of the bulb to be replaced. Tilt your light slightly and it should come out. Without the online videos, it would have been difficult to find all of the clips and screws without breaking something. Also, make sure its headlights are switched off. Push piano wire from the interior of vehicle outward and place some sort of handle to control the wire.